Akron-RS Pro 牌照架

【メーカー品番】280-819HP

HIGHSIDER AKRON-RS PRO license plate holder incl． license plate light

The HIGHSIDER AKRON-RS PRO license plate holder adapts perfectly to the lines of your bike thanks to its design．

The model-specific bracket of the HIGHSIDER AKRON-RS PRO allows mounting on the original mounting points of your bike and thus a replacement without further drilling or cutting．
To prevent damage to cables， all sharp-edged feedthroughs are protected by a rubber membrane grommet．

The license plate is made of sheet steel and 2 mm thick． The precise cutting is done by laser． After edging， the weather-resistant black powder coating is applied．
This ensures the optimal fit and durability．
Through the stepless adjustment you can bring the plate without drilling in the desired position． To keep the plate in this position， there is an additional locking screw．

The turn signal brackets on the HIGHSIDER AKRON-RS PRO are adjustable in width， making them suitable for any type of accessory turn signal． This adjustment option allows you to adapt the position for your turn signals to the most varied number plates． To allow mounting the turn signals without disconnecting them from the wiring harness， the 10 mm holes are slotted to the side．

You can also adjust the position of the reflector individually via a slider． An adaptation to the different designs of the EU license plates is therefore no problem．

To screw the license plate securely and reduce vibration， two rubber washers are included． Another rubber buffer supports the license plate on its underside．

Included in this PRO version of the HIGHSIDER AKRON-RS is the very small HIGHSIDER license plate light machined from high quality aluminum with mounting plate and support arm． The bracket is adjustable in height and designed to allow mounting in the legally required position．

Details:

- model-specific bracket
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy mounting without cable separation
- infinitely adjustable reflector， E-approved
- suitable for European number plates
- infinitely adjustable tilt angle
- additional screw for optimum position security
- easy fixation without further work steps (eg．e．g． drilling)
- easy mounting of the license plate through slotted holes
- license plate light incl． Holder included
- license plate light， E-approved
- infinitely adjustable license plate light
- many different options for mounting the license plate light

The scope of delivery of the HIGHSIDER AKRON-RS PRO includes:

- Model specific bracket with mounting hardware
- HIGHSIDER AKRON-RS license plate retainer plate
- Adjustable turn signal brackets
- E-tested reflector with adjustable bracket
- E-tested license plate light
- Mounting instructions

Notes:
- If there are side reflectors fitted to your original number plate holder， these must be refitted in a suitable position or replaced with new ones．
- The special turn signal holder 280-976 is optionally available for the original turn signals．

Tip:
If you have not found a model-specific license plate holder for your vehicle， the universal license plate holders from HIGHSIDER， which are available in many different designs， are certainly a good alternative．

※ ナンバープレートサイズが日本の規格ではありませんので、取り付ける際にはステーによる加工などが必要なりますのでご注意下さい。
※ 輸入品のため、説明書が付属する場合、外国語の説明書となります。
※ メーカー都合により商品の仕様変更がある場合がございます。ご了承ください。